Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT AC (HI VOLTAGE TEST) VOLTAGE SHOULD APPLY FOR 33KV
CABLES.EXPLAIN IN DETAIL
- 12 Answers
- 22843 Views
- NTPC, Voltech, I also Faced
- E-Mail Answers
Answer Posted / blake australia
A lot of HV cables are XLPE not PVC. If you Megger a 33kV
cable with a DC voltage then you may damage the XLPE
semiconductor around the cable.
Industry standard in Australia(although very expensive to
buy one) is to use a VLF (very low frequency) tester to
test the cables. Same principal as mentioned, just uses an
AC waveform (~.1Hz) opposed to a DC waveform.
| Is This Answer Correct ? | 5 Yes | 14 No |
Post New Answer View All Answers
What is ST and specify its range of voltage.
what is the id1 & id2 setting in differential protection relay of CSPC?
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
how calculated Transformer losses.
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
why we are not giving the zone 1 trip command to the master trip relay
Formulae for calculating the transmission line losses for different voltage levels
what will happen if synchronous machine rotor fed from single phase ac supply
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
operation of protection relay watchdog contact?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
full form of electrical?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
How the annunciator works ? How to do its wiring
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
