Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between isolation and insolation ?
please explain in detail with example.
- 5 Answers
- 24511 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / saravanababu
isolation:
in transmission line to separate the two live
parts..example for in trasformer
insulation:
to separate the live part to earth part..example for
transmission line..
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
what is meant by power and distribution transformer ?
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
Why star delta starter is preferred with induction motor?
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
what is the meaning of 5% droop or 7% droop in AVR?
what is servo motor & how does it work.
I AM FROM ELECTRICAL ENGINEERING ? I AM ASPIRING FOR "BHEL".HOW I HAVE TO PREPARE .ON WHICH TOPICS TO BE CONCENTRATE MORE.PLEASE GIVE FULL DETAILS OF WRITTEN EXAM.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
Why ground terminal is used in pot meter 10k ohms
HOW TO CALCULATE EARTHING SIZING?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
