Interested to Buy Any Domain ? << Click Here >> for more details...
The neutral to earth connection in my industry is showing a zero reading
(shorted). I have a machine which has to be installed where neutral to earth is
not shorted and shows a leak voltage <3 Volts. Please suggest me how it is
possible.
- 6 Answers
- 10438 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravi mittal
Dear Bikash,
I am thankful to you for taking interest in answering my
query.
Actually, I have an equipment for which I have been clearly
indicated to not have neautal and earth shorted. If done
so, the equipment may have problems in future. When we
check with the multimeter the neautral to earth is showing
as shorted which gives a zero reading which is actually not
shorted. What can I do in this case where can I either get
a 0 reading (when not short) or <3 volts reading? Is there
a fault with my wiring? Some electricians say that this is
a usual phenomenon in industrial areas. If the phenomenon
is usual, is there a device which can be installed to
rectify this problem.
Thanks and regards,
Ravi Mittal
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
State thevenin’s theorem?
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
how technical is calculated in 11kv line and lt line
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
what is the Pickup/drop off ratio in BCPU relays
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
What is meant by positive and negative feedback?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
How will you define capacitance?
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
Why we use circular(Stepped) cross section in transformer core?
What happens to voltage when current is zero?
