Interested to Buy Any Domain ? << Click Here >> for more details...
Are there characteristics of a system that cannot be
established during system engineering activities? Describe
the characteristics, if any, and explain why a
consideration of them must be delayed until later
engineering steps.
- 1 Answers
- 3318 Views
- I also Faced
- E-Mail Answers
Answer / ketan korat
When putting a system together, the different components
interacting may show unexpected behaviors. It is hard to be
able to predict these completely.
A typical example happens in power plants when running steam
boilers or power generators in parallel. The load is not
distributed evenly, as would happen on a stand alone unit,
but needs to be constantly tweaked.
In addition, there are unexpected configurations resulting
from the installation itself, which create unstable modes
due to interaction. These must be addressed and proper
compensation through the control system be applied,
| Is This Answer Correct ? | 1 Yes | 0 No |
Explain the main differences between software review and software inspection or walkthrough
what are the differences between smoke and sanity testing
Give a suitable definition of software quality and briefly describe the rationale for your definition.
anybody knows about the industrial visit companies in chennai?
how to calculate defect density rate and what are the retrospective mesures you have experienced / taken to reduce the same
How do you test the middleware ? esp for an Online Banking software?
compare all the models of software development. write advantages and limitations of each.
How would you do an Estimation?
When we write Test cases? & Why we will write Testing?
what are the usual metrics one have to apply for SW improvement projects
is all the test cases to be automized !!! if yes / no let explain the reason
Hi Friends... I faced an question in Tcs.But i unable to answer. find the question below.. A root filesytem"c0t0d0s0" caries 100 gb data. in this filesystem. i am having 3 files named a,b,c it caries 20 gb data each. I need to take backup only 3 files a,b,c. How i can take. Note you need to take only 3 files to an single tape having capacity 80 gb. Whats the commad used?
Requirement Management 
