Which address or number is used to pass the data to the
correct application?
MAC Number

IP address

Port Number

Segment Number

Answers were Sorted based on User's Feedback



Which address or number is used to pass the data to the correct application? MAC Number ..

Answer / jitendera sinha

correct application?


answer should be port number

Is This Answer Correct ?    9 Yes 0 No

Which address or number is used to pass the data to the correct application? MAC Number ..

Answer / vino alosius

IP address

Is This Answer Correct ?    0 Yes 4 No

Post New Answer

More CCNA Interview Questions

Identify the command to view the configuration-register value? A.) show register B.) display config-register C.) show config D.) show version

1 Answers  


How we ping ICMP a NIC with a correct IP address but with wrong MAC address Do all NIC's can run inpromiscuous mode

3 Answers   Cisco, HCL,


Which encapsulation methods are most commonly used with dialup Integrated Services Digital Network (ISDN)? A. IP and IPX B. IP and PPP C. PPP and SDLC D. PPP and HDLC

2 Answers  


What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services

3 Answers  


What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II

1 Answers  






Which show underrate serial 1 status statement indicates that the shutdown command was issued on that interface? A. Serial 1 is up line protocol is up B. Serial 1 is up line protocol is down C. Serial 1 is down line protocol is down D. Serial 1 is administratively down the line protocol is down

2 Answers   Pioneer Labs,


The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full

1 Answers  


Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down

0 Answers   Infosys,


what is difference between 1 pap and chap(quite easy but need on line answer) 2 chap and ms-chap(plz describe briefly) now i have posted the question is there any one to help me?

2 Answers  


What is the terminal emulation?

0 Answers  


Which addresses are valid host addresses? A. 201.222.5.17 B. 201.222.5.18 C. 201.222.5.16 D. 201.222.5.19 E. 201.222.5.31

2 Answers   VGH,


Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link

2 Answers  


Categories