Which protocol used before part of ccna?

0 Answers  

---

What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

3 Answers  

---

What is the size of ipv6?

0 Answers  

---

Explain the term 'multicast'.

0 Answers  

---

How many valid host IP addresses are available on the following network/subnetwork? 176.12.44.161/30 A. 2 B. 30 C. 254 D. 16,382 E. 65,534

4 Answers   Cisco,

---

---

Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch

3 Answers  

---

Based upon the exhibit, create a static route to 172.16.10.0 on Router A A.) Router# ip route 172.16.10.0 255.255.255.0 10.1.0.2 B.) Router(config)# ip static route 172.16.10.0 255.255.255.0 10.1.0.2 C.) Router(config)# ip route 172.16.10.0 10.1.0.2 D.) Router(config)# ip route 172.16.10.0 255.255.255.0 10.1.0.2

1 Answers  

---

An autonomous system can only exist if all routers in that system meet which criteria? A. interconnected B. run the same routing protocol C. assigned same autonomous system number D. run IGRP only E. run RIP only

1 Answers  

---

What do you understand by poe (power over ethernet)?

0 Answers  

---

Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash ftp D. copy tftp flash

2 Answers  

---

What is the beaconing?

0 Answers  

---

What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route

1 Answers  

---