Interested to Buy Any Domain ? << Click Here >> for more details...
Suppose in SNMP managed Network, Network card of one machine
fails then how Management Devices comes to know about this
machine and suppose in other case machine gets shutdown then
how it will be recoginised.
- 7 Answers
- 13703 Views
- Mphasis, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / gilli
Two question asked are
1. N/w card fialure
2. Agent Shutdown
In the above two cases Traps are not sent. Manager gets to
know if he gets a timeout for the snmp request sent to the
device.
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / farooq.j
1. N/w card fialure
2. Agent Shutdown
Two cases Traps are are not sent.
This Condition easyly Known from SNMP Object In the System
Group i.e SysUpTime.
This is useful even if we are not implemented traps.
Procedure :
Plot The Gaph for SysUpTime Object from any MIB
browser ,then when the system goes shutdown.it stops at One
point in the Graph .Note that time.again when the system
runs the timer comes to zero and start incrasing.
by using this we know exact time when the system goes
down and when it is up.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / m.kumararaja
Agent will send the trap to manager.
These problems or defined in the generic trap type, i.e
Linkdown, link up,cold start, warm start... So any [roblem
occurs in the device agent can sent the trap wwith the
above trap types, so we can find easily what problems
occured in the device.
if this answer not exact please send correct one.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / sashank
A trap can be sent only when a system/ device comes back ,
while shutting down there is no way it can send a trap ..
so only way is we need to constantly poll for the health of
devices or else wait until it comes back to recieve a trap
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / debasis
By ping one can know the destionation reachabillaty..for
snmp we can use snmp walk
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / vikram malhotra
If you have configured Trap then any of the NE or system
will get shutdown on reboot then Manager will get a trap /
Event. which says that you machine is reboot or getting
shutdown.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / debasis
If any card is down then agent can send a trap and if the
machine gets shut down also it can send a trap.
But in case agent crashes then there should some health
check module which will check the status of hardware or
agent and if it is down then it should start the agent service.
All the above answer are partial correct because there
nothing specific answer on this. This depends on the
requirement.
| Is This Answer Correct ? | 0 Yes | 0 No |
What is FSB?
what is the mean of networking? what is the difference between this from programming language?
Repeater used in which layer of TCP/IP protocol? a. Application b. Physical c. Network d. Transport
Multiple Choice Which of the following protocols are in TCP/IP protocol suite? FTP PPP HTTP IP SMTP
what is the difference between configurationa and installment ?
RIP has a long convergence time and users have been complaining of response time when a router goes down and RIP has to reconverge. Which can you implement to improve convergence time on the network? A) Replace RIP with static routes B) Update RIP to RIPv2 C) Update RIP to OSPF using Link State D) Replace RIP with BGP as an exterior gateway protocol
How SNMP communicates to Managed Devices and Do it takes help of other protocols?
what is the use of proxy in SNMP.Does it require only when the network has snmpv1 and snmpv2.
What network u used ?
2 Answers ABC, Infosys, Siemens,
A COM PORT IS A----------- PORT
What is the broadcast address of the subnet address172.16.8.159\25?(choose from following) 172.16.99.255 172.16.127.255 172.16.255.255 172.16.64.127 172.16.64.260
what is eps
SNMP 
