What is the difference between switch, routers, and hub?
No Answer is Posted For this Question
Be the First to Post Answer
Explain what is overlaod?
What is subnetting? Why is it used?
Most routing protocols recognize that it is never useful to send information about a route back out the direction from which the original packet came. This is an example of which routing technology? A.) Split Horizon B.) LMI C.) Triggered Updates D.) Poison Reverse E.) SYN, ACK F.) DLCI
What do you understand by poe (power over ethernet)?
Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25
What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace
Identify the following components of the IPX address 2e.0000.0065.ed43 A.) Not a valid IPX address B.) Network = 2e, Subnet = 0000, Node = 0065.ed43 C.) Network = 2e.0000, Node = 0065.ed43 D.) Network = 2e, Node = 0000.0065.ed43
1350 Value in which type of access-list?
Identify the switching method that examines the destination MAC address as the frame is being received then begins forwarding the frame prior to receiving the entire frame? A.) Fragment-free B.) Store and Forward C.) Cut-through D.) Fast forward
Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary port B.) ROM port C.) Management port D.) Console port
Where shall i do CCNA cour??. can i do CCNA at home if yes then where shall i get CCNA book or simmulator.or if not then plz reff. me any good center in delhi
You are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem? A. NetWare 4.11 defaults to 802.2 encapsulation. B. NetWare 4.11 defaults to 802.3 encapsulation C. Cisco routers only work with NetWare 3.11. D. NetWare 3.11 defaults to 802.2 encapsulation.