Which command will copy the routers configuration from NVRAM to a Network fi

Which command will copy the routers configuration from NVRAM
to a

Network file server?

A.) copy start tftp

B.) copy start tftp server

C.) copy tftp startup-config

D.) copy running-config tftp

E.) copy startup-config tftp

Question Posted / guest

1 Answers
8246 Views
I also Faced
E-Mail Answers

Which command will copy the routers configuration from NVRAM to a Network file server? A.) co..

Answer / guest

Answer: A E

Is This Answer Correct ?

10 Yes

2 No

Post New Answer

More CCNA Interview Questions

What is the mesh network?

0 Answers

Switching methods include cut-through, store and forward, and a modified version of the first two methods. Which statement about switching methods is true? A. The store and forward method has low latency B. The cut through method of switching has high latency C. The modified version holds the packet in memory until 50 percent of the packet reaches the switch D. The modified version holds the packet in memory until the data spoon of the packet reaches the switch

3 Answers

What is a vlan?

0 Answers

What is the standard ISDN term for a non-native analog telephone? A.) TE1 B.) TA C.) LE D.) TE2 E.) ET

1 Answers DELL,

Briefly explain the conversion steps in data encapsulation.

0 Answers

Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25

1 Answers

What is VLSM ?

5 Answers HCL,

LAN stands for which of the following? A.) Local Area Network B.) Local Arena Network C.) Local Area News D.) Logical Area Network

3 Answers

The CSMA/CD Ethernet IEEE committee is defines as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5

1 Answers

Which OSI layer supports the communication component of an application? A.) Data-Link B.) Physical C.) Session D.) Presentation E.) Application F.) Transport

1 Answers

Identify the command that disables name-to-address translation? A.) Router(config-dns)# no ip domain-lookup B.) Router(config)# no address translation C.) Router(config)# no ip domain-lookup D.) Router(config)# ip domain-lookup

1 Answers

Which command will give the following output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 0 CTY - - - - - 0 0 0/0 - 1 AUX 9600/9600 - - - - - 0 0 0/0 - * 2 VTY - - - - - 2 0 0/0 - 3 VTY - - - - - 0 0 0/0 - 4 VTY - - - - - 0 0 0/0 - 5 VTY - - - - - 0 0 0/0 - 6 VTY - - - - - 0 0 0/0 -

1 Answers

For more CCNA Interview Questions Click Here