Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction

1 Answers  

---

Which information must a router know in order to perform proper and pungent routing? A. destination application of an incoming packet B. number of other packets in a single flow of data C. destination network address of an incoming packet D. number of routers that also know a path to the destination

1 Answers  

---

What does the ping response & mean? * A: unreachable * B: congestion * C: user interrupt * D: unknown packet type * E: lifetime exceeded

6 Answers  

---

What is the purpose of data link layer?

0 Answers  

---

Identify the following components of the IPX address 2e.0000.0065.ed43 A.) Not a valid IPX address B.) Network = 2e, Subnet = 0000, Node = 0065.ed43 C.) Network = 2e.0000, Node = 0065.ed43 D.) Network = 2e, Node = 0000.0065.ed43

1 Answers  

---

What is the difference between TCP and UDP? A.) TCP is connection-oriented; UDP uses acknowledgements only B.) TCP is connection-oriented; UDP is connectionless C.) Both TCP and UDP are connection-oriented, but only TCP uses windowing D.) TCP and UDP both have sequencing, but UDP is connectionless

4 Answers  

---

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers  

---

As a system administrator, you need to provide your routers with a Domain Name System (DNS) server. How many DNS servers can you specify with one command? A. 6 B. 1 C. 2 D. 4

1 Answers  

---

Station A is transmitting data to station B faster that station B can handle it. When station B's buffer fills up, it send out a message to station A to stop sending data. After B empties out its buffer, station B sends a message to station A to start sending data again. This is most directly an example of (pick the best answer only): A.) Poison Reverse B.) Connectionless protocol C.) Windowing D.) Connection oriented protocol E.) Flow Control F.) Split Horizon

1 Answers  

---

Station A is transmitting data to station B, and expects an acknowledgment after every 400 bytes. After transmitting data for a while, the two stations determine the line is reliable and change to expecting and acknowledgement every 600 bytes. This is an example of (pick the best answer only): A.) BECN B.) Sliding Windows C.) Poison Reverse D.) Countdown timers E.) Split Horizon F.) Count to infinity

1 Answers  

---

What are the advantages of a layered model in the networking industry?

0 Answers  

---

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---