Which ipsec rule is used for the olympia branch and what does it define? (Choose two)

0 Answers  

---

Which layer of the 7 layer model provides services to the Application layer over the Session layer connection? A.) Transport B.) Application C.) Session D.) Network E.) Datalink F.) Presentation

2 Answers   CTS,

---

Identify 2 features of X.25? A.) Supports only IP B.) Utilizes switched and permanent virtual circuits C.) Contains minimal flow control and error recovery D.) Utilizes LAPB as it's data-link protocol

4 Answers  

---

What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable

1 Answers  

---

What is the logical link control?

0 Answers  

---

Which protocol comes under hybrid dynamic type?

0 Answers  

---

In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?

0 Answers  

---

what is ip address and what is the difference between the ip address and mac address why we are not using mac address instead of ip address

4 Answers   IBM,

---

Hi, All I am configuring EIGRP in Packet tracer, after configuring all the things it is not working but in one condition it is working fine if i am putting all my router and network withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but whenever i am puting different network subnets e.g. in one network it is RA(config-if)#=ip address 10.0.0.1, and in fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in third router RC(config-if)#=ip address 11.0.0.2 and in fa 0/0 172.16.1.10 and after configuring all this serial is showing up and protocol showing up but eigrp process not taking place after adding eigrp configuration, i tried with "no auto-summary" command but not working.. Suggest me where i missing something? can mail me at : gtech.innovator@gmail.com

20 Answers  

---

Explain what is formula of hold down time of eigrp protocol?

0 Answers  

---

What is the difference between the communication and transmission?

0 Answers  

---

Sequence and acknowledgement numbers are used for? A.) Layer transitioning B.) Flow control C.) Port number addressing D.) Reliability

1 Answers  

---