What are the different IPX access lists?

0 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make fowarding decision using MAC address E.) Create collision domains

1 Answers  

---

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#

1 Answers  

---

How do we do encryption and authentication in L2F?

0 Answers   CCIE,

---

Routers can learn about destinations through static routes, default, or dynamic routing. By default, a router will use information derived from __________. A. IGRP B. RIP C. IP D. TCP

2 Answers   pspl,

---

---

If line up, but protocol down which layer should be troubleshot?

0 Answers  

---

What is the difference between TCP and UDP? A.) TCP is connection-oriented; UDP uses acknowledgements only B.) TCP is connection-oriented; UDP is connectionless C.) Both TCP and UDP are connection-oriented, but only TCP uses windowing D.) TCP and UDP both have sequencing, but UDP is connectionless

2 Answers  

---

Bridges work at what layer of the OSI model? A.) Data Link B.) Network C.) Physical D.) Application

12 Answers   KVS, PGT,

---

A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?

2 Answers   Satyam,

---

You just entered the following command_Router(config#) line console 0 Which operation is most likely to follow? A. Confound terminal type B. enter protocol parameters for a serial line C. create a password on the console terminal line D. establish a terminal type 4 connection to a remote host E. change from configuration mode to console privileged mode

10 Answers   Intel, Quark, Wipro,

---

What are two functions of the ICMP protocol? (Choose two) A. to map IP addresses to Ethernet addresses B. to map common names to network addresses C. to forward SNMP alerts to management consoles D. to generate an echo reply in response to a ping test E. to send a host or pod unreachable message from a router to the source of an undeliverable packet

1 Answers  

---

What is the beaconing?

0 Answers  

---