Of the following characteristics, which apply to UDP? Connection-oriented Connectionless Error checking Low overhead Best-effort delivery

5 Answers  

---

What is the updates time of routing table,and what is the invalid timer, and also what is the flush timer in IGRP and EIGRP?

1 Answers   HP,

---

Of the following switching types, which one has the lowest latency? A.) Cut-through B.) Fragment Free C.) None D.) Store-and-forward

3 Answers  

---

What is bia?

0 Answers  

---

i want to ask one question that why u guys are not posting the questions is any thing wrong please post question for your and others including me knowledge

3 Answers  

---

Identify 3 features of IGRP? A.) Composite metric B.) New horizon C.) Flash updates D.) 60 periodic updates E.) Poison reverse

1 Answers  

---

Which of the following use PVCs at layer 2? A.) X.25 B.) HDLC C.) Frame relay D.) ISDN

1 Answers  

---

thnx Jitender singh...as u told to install a stp in switches and problem vil b get solved...i wanna kno how to install stp in switches?? plz tel me detailled steps... thanx for ur answer.

1 Answers  

---

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

1 Answers  

---

After the command -- router igrp 200 -- what command would enable IGRP on the router for interface E0, with an address of 157.89.4.4 and a mask of 255.255.255.0 ? A.) network 157.89.4.0 255.255.255.1 B.) network 157.89.0.0 C.) router igrp * D.) router igrp 157.89.0.1 E.) router igrp int e1 F.) router igrp 157.89.4.1

2 Answers  

---

Which protocol can do load balancing on unequal cost also?

0 Answers  

---