In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More CCNA Interview Questions

On which base distance vector choose best path?

0 Answers  


what is the distance betwwen link stae routing protocl and distance vector who have the best convergence toplogy eigrp conatain 3 table name them what the toplogy table contain

5 Answers   IBM,


Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department

1 Answers  


A router blocks ___________ Broadcasts Unicasts All packets Nothing

1 Answers  


WAN stands for which of the following? A.) Wide Arena Network B.) World Area Network C.) Wide Area News D.) Wide Area Network

2 Answers  






Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers  


hello i am new to this, i need to know how will i complete a basic scenario that ask the required number of networks that is 80 and the minimum number of host that is 3000 and the network address is 10.0.0.0 and i need to need how to compute to get the answer on what is the subnet mask.

3 Answers   Kaplan,


Which OSI layer provides best effort end to end packet delivery? A.) Data-Link B.) Presentation C.) Network D.) Transport E.) Physical F.) Application

3 Answers   Barnes and Noble,


What do the following commands accomplish? access-list 1 permit 172.16.0.0 0.0.255.255 interface ethernet 0 IP access-group 1 out interface ethernet 1 IP access-group 1 out A. Only traffic from the source network 172.16.0.0 will be blocked. B. Only traffic from the source network 172.16.0.0 will be forwarded. Non-172.16.0.0 network traffic is blocked. C. Non-172.16.0.0 traffic will be forwarded. D. All traffic will be forwarded.

1 Answers  


Which command would you type to show SAP and RIP updates you are receiving on an interface? A.) sh ipx servers B.) sh ipx traffic C.) sh ipx interface D.) sh ipx route

2 Answers  


Which command sets IGRP as the routing protocol for autonomous system 100? A. Router(config)#igrp 100 B. Router(config)#network 100 C. Router(config)#router igrp 100 D. Router(config)#enable igrp 100

1 Answers  


In the command "router igrp 109" what does 109 signify? A. an autonomous system B. any network number which the router is attached to C. the allowable length of the routing table D. the network socket number

1 Answers  


Categories