What AppleTalk protocol permits AppleTalk workstations to
share files across a network?
- 1 Answers
- 3476 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: AFP or AppleTalk Filing Protocol
AppleTalk Filing Protocol (AFP) permits AppleTalk
workstations to share files across a network. This question
did not specify whether or not you were supposed to type the
acronym or the complete answer.
| Is This Answer Correct ? | 0 Yes | 0 No |
difference between layer 3 switch and router
0 Answers Aptron, Tech Mahindra,
Which router would you choose for your design? A. 1600 B. 1700 C. 3600 D. 3640 E. 7200
Distance Vector and Link-State protocols converge more quickly if: A. there is router redundancy B. there is router redistribution C. the update interval is set to its maximum D. the whole routing table is sent to announce changes
What is the technique used by a router that can automatically initiate and close a circuit-switched session? A. PLP B. LAPP C. ASN.1 D. DDR
The following are the four steps in establishing an X.25 virtual circuit. Place them in the correct order. A. The PSE (Packet Switch Exchange) passes the packet to the next remote DCE B. The local DCE packet binder sends packet to the closest PSE (Packet Switch Exchange) C. The source DTE sends packet to the local DCE D. The remote DCE examines the packet header of destination DTE
What are metrics used with IGRP? A. Ticks B. Load C. Hops D. Delay
How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration： CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !
What category or categories does Client/Server fit into the following Job Aid? Name of Protocol Type of Protocol # of Users # of Hosts or Servers Comments
What is the first step in diagramming packet flow for the terminals within a network? A. Identify the end user nodes of all the terminals B. Figure out the speed of all the servers C. Find out where all the routers are located D. Find out where all the switched are located
What are two differences between 10BaseT and 100BaseT? A. Speed B. Frame format C. Addressing D. Network diameter
What is the standard ethernet cabling specification? (not IEEE 802.3) A. STP B. Coax (thin) C. Coax (thick) D. UTP
When is the route to a node determined in an SRB (Source Route Bridging) Token Ring network? A. Before any data is transmitted B. After the data is transmitted C. During the transmission of data D. After the first frame is transmitted
CCNA 
