What is the total bandwidth of all channels on a BRI circuit?
A. 56 kps
B. 64 kps
C. 112 kps
D. 128 kps
E. 144. kps
Answers were Sorted based on User's Feedback
Answer / iiht
E and 144kbps
In BRI, 2B-channel & 1D-channel = (2x64)+16 = 144kbps
Is This Answer Correct ? | 10 Yes | 1 No |
FastEthernet compares to 10baseT Ethernet in which of the following ways
what is the difference between hdlc and ppp protocol
Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link
When dr communicate with bdr which multicast ip it use?
Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification
What is a backoff on an 802.3 networks A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. it is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged.
Which layer of the 7 layer model provides services to the Application layer over the Session layer connection? A.) Transport B.) Application C.) Session D.) Network E.) Datalink F.) Presentation
What do the following commands accomplish? access-list 1 permit 172.16.0.0 0.0.255.255 interface ethernet 0 IP access-group 1 out interface ethernet 1 IP access-group 1 out A. Only traffic from the source network 172.16.0.0 will be blocked. B. Only traffic from the source network 172.16.0.0 will be forwarded. Non-172.16.0.0 network traffic is blocked. C. Non-172.16.0.0 traffic will be forwarded. D. All traffic will be forwarded.
Which ISDN protocol prefix specifies switching and signalling? A.) I B.) E C.) Q D.) S
What is Spanning Tree Protocol and how it work? I know it is - STP is Spanning tree Protocol. It Stops the looping in the network? How STP work? How it stop Looping in network?
Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename
What is the protocol number for TCP? A.) 80 B.) 21 C.) 11 D.) 6