Answer / guest

Answer: A, D

What is difference between baseband and broadband transmission in ccna?

0 Answers  

---

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---

Which layer is responsible for providing mechanisms for multiplexing upper-layer application, session establishment, and tear down of virtual circuits? A.) Session B.) Network C.) Physical D.) Transport E.) Application F.) Presentation

1 Answers  

---

what is the difference between osi and tcp ?

8 Answers   Wipro,

---

Which show underrate serial 1 status statement indicates that the shutdown command was issued on that interface? A. Serial 1 is up line protocol is up B. Serial 1 is up line protocol is down C. Serial 1 is down line protocol is down D. Serial 1 is administratively down the line protocol is down

2 Answers   Pioneer Labs,

---

---

Describe ICMP messages

4 Answers   HCL,

---

Which company mange ip's?

0 Answers  

---

hi friend i am stuck in the big problem.this problem is regading pix firewall. i have a cisco pix 515e firewall inmy company.now when i configure it and after rebooting it the ACT link never getup.when i apply clear config all comand the ACT link get up after oveservation i see that there is fauilover problem when i apply failover active ACT link agin get up is there any way to get my firewall in standby mode rember that there is only on firewall within my n/w i am lookig towards all of you jitendera kumar sinha

0 Answers  

---

What does 'P' mean when running a Trace? A.) Good route B.) Protocol unreachable C.) Source Quench D.) Destination unreachable

1 Answers  

---

How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds

2 Answers  

---

What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

3 Answers  

---

What purpose does aging serve in a link state protocol?

0 Answers  

---