Which of the following are Transport layer protocols?
A.) UDP
B.) TCP
C.) NBP
D.) IP
E.) SPX
Answers were Sorted based on User's Feedback
Explain how many types of ends in wan?
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
What is a back off on an 802.3 networks? A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. It is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged
Identify the hardware component that stores the backup configuration? A.) RAM B.) NVRAM C.) Flash D.) ROM
Hi Guys i hv one confusion. Need u peoples help. In EIGRP, maximum hop count is up to 255. By default only 100. Now question is - a) Suppose i hv a network consist of 115 routers & EIGRP routing protocol is configured. By default hop count is 100, so is there any manual configuration necessary for hop count ya router will automatically detect the hop count & will update the hop count accordingly..????? b) In EIGRP, Bandwidth & Delay is used to calculate metric. For this Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0 Now i want, Bandwidth & Load is used to calculate metric. For that wat i hv to configure & wat wub the metric weights. Cud anyone explain it plzzzz..!!!!
Identify 3 LAN technologies? A.) FDDI B.) HDLC C.) HSSI D.) X.25 E.) 802.3 F.) 802.5
Although Cisco IOS 11.2 and later can auto-detect the LMI type in Frame Relay, which command will force the LMI type to q933a? A.) frame-relay lmi-type q933a B.) encapsulation frame-relay q933a C.) don't need to, it is the default D.) encapsulation q933a E.) encapsulation frame-relay type=q933a
In regards to the ISDN BRI standard, which channel is used for control? A.) B B.) D C.) E D.) I E.) Q
Which type of switching is considered to be 'wire speed?' A.) Cut-Through B.) Multiplexed C.) Inverted D.) Layer 4 E.) Store and Forward F.) Layer 3
what is the difference between dynamic NAT and NAT overload ? and how it works ?
Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A. trace B. ping C. telnet D. bootp
Identify the command to display all the valid commands at the given mode? A.) Help all B.) Help C.) All commands D.) ?