Interested to Buy Any Domain ? << Click Here >> for more details...
Which layer of the 7 layer model is responsible for
representing the
application information between 2 different OS's? For
example, converting
ASCII to EBCIDIC.
A.) Transport
B.) Application
C.) Physical
D.) Session
E.) Presentation
F.) Network
- 2 Answers
- 5891 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Identify the command that displays traffic statistics on serial0/1? A.) display interface serial0/1 B.) show interface serial0/1 C.) show seria0/1 stats D.) show interface serial0/1 stats
Explain the difference between switch & hub?
IGRP uses flash updates, poison reverse updates, holddown times, and split horizon. How often does it broadcast its routing table updates? A. 90 seconds B. 10 seconds C. 30 seconds D. 45 seconds
. Which command sequence will allow only traffic from network 185.64.0.0 to enter interface s0? A. access-list 25 permit 185.64.0.0 255.255.0.0 int s0 ; ip access-list 25 out B. access-list 25 permit 185.64.0.0 255.255.0.0 int s0 ; ip access-group 25 out C. access-list 25 permit 185.64.0.0 0.0.255.255 int s0 ; ip access-list 25 in D. access-list 25 permit 185.64.0.0 0.0.255.255 int s0 ; ip access-group 25 in
the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected??
Which ISDN protocol prefix specifies switching and signaling? A.) I B.) E C.) Q D.) S
How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain
Which layer defines the physical topology? A.) Application B.) Transport C.) Network D.) Data Link E.) Physical F.) Session
The default routing protocol for IPX is IPX RIP. How do you view the routing updates sent and received by the router? A.) debug ipx routing B.) debug ipx routing activity C.) debug rip D.) show ipx routing E.) sh ipx F.) debug ipx rip
What are the netbios and netbeui?
in stead of 0.0.0.0 wild card mask what u can write after ip?
Explain the difference between rip and ripv2?
CCNA 
