Which of the following do not belong to the customer?
A.) CO
B.) DCE
C.) Router
D.) CPE
E.) Demarc
F.) DTE
What is a Window in networking terms?
Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A) telnet B) ping C) trace D) bootp
Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not a the same time
Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252
Which one is the Best protocol- Static routing, RIPV2,EIGRP,OSPF.
20 Answers EIGRP, HP, Tech Mahindra, Wipro,
Which technologies listed below help prevent network loops in a switched (bridged) environment? A.) Store-and-Forward B.) IEEE 802.1d C.) Diikjstra Algorithm D.) Cut-Through E.) Spanning Tree Protocol F.) Routing
Can you explain PAP?
You are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem? A. NetWare 4.11 defaults to 802.2 encapsulation. B. NetWare 4.11 defaults to 802.3 encapsulation C. Cisco routers only work with NetWare 3.11. D. NetWare 3.11 defaults to 802.2 encapsulation.
What are 10base5 ethernet lans?
what is the full fom of ping
Which global configuration command will tell the router to load the IOS file 'IOS_filename' from the Network File server at 1.2.3.4 during the next boot? A.) boot system flash IOS_filename 1.2.3.4 B.) boot system tftp IOS_filename 1.2.3.4 C.) config-register 0x0 1.2.3.4 D.) boot system rom 1.2.3.4 E.) This can not be done, only the first file in flash can be used.
Mention the conversion steps of data encapsulation?