Identify the hardware component that stores the bootstrap program? A.) ROM

Identify the hardware component that stores the bootstrap
program?

A.) ROM

B.) NVRAM

C.) Booter load

D.) RAM

E.) Flash

Question Posted / guest

4 Answers
13906 Views
Wipro, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) B..

Answer / guest

Answer: A

Is This Answer Correct ?

20 Yes

0 No

Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) B..

Answer / lou

Bootstrap,POST and mini-IOS(bootloader)are stored in ROM.
Flash,is an EEPROM,holds the Cisco IOS.
RAM holds running configuration, ARP cache and routing
tables. NVRAM holds the router/switch startup
configuration.

Is This Answer Correct ?

5 Yes

2 No

Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) B..

Answer / amar

A. Rom

Is This Answer Correct ?

2 Yes

1 No

Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) B..

Answer / mani007ccna

NVRAM its ly hold and update the status of IOS

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More CCNA Interview Questions

Identify the command that displays ethernet0/1 interface status? A.) show interface ethernet0/1 B.) show interface ethernet e0/1 C.) show interface ethernet0.1 D.) show ethernet0/1

3 Answers

What is bgp?

0 Answers

What is a L2F protocol?

1 Answers CCIE,

What command would show the version of the IOS that you are running? A.) show nvram B.) show version C.) show startup-config D.) show ios E.) ver -a F.) show ram

1 Answers

Which of the following is a connectionless protocol at the Transport layer? A.) UDP B.) ARP C.) ICMP D.) RARP E.) IP F.) FTP

2 Answers

GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong

0 Answers

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers Wipro,

what is subnet mask?

5 Answers HCL,

When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?

4 Answers

6. Which device can create smaller networks and stop broadcast storms by default? A. Repeater B. Bridge C. Router D. Gateway

4 Answers

What is topology in ccna?

0 Answers

how to shutdown a Cisco router from command prompt?

11 Answers Atlas Systems, HCL,

For more CCNA Interview Questions Click Here