Assume that you are editing a line of text on a Cisco
router. What

key-stroke combination would take you to the beginning of
the line?

A.) CTRL-B

B.) CTRL-Z

C.) CTRL-

D.) CTRL-A

E.) CTRL-

F.) CTRL-

Answers were Sorted based on User's Feedback



Assume that you are editing a line of text on a Cisco router. What key-stroke combination would ..

Answer / guest

Answer: D

Is This Answer Correct ?    5 Yes 1 No

Assume that you are editing a line of text on a Cisco router. What key-stroke combination would ..

Answer / javid

B.) CTRL-Z

Is This Answer Correct ?    1 Yes 4 No

Post New Answer

More CCNA Interview Questions

What is BootP?

0 Answers  


What are two ways IPX supports multiple logical networks on an individual underrate? (Choose two) A. network number B. routing protocol C. encapsulation type D. autonomous system number

1 Answers  


Which ISDN specification deals with call Setup and Teardown? A.) Q-Series B.) J-Series C.) I- Series D.) C- Series E.) F-Series

1 Answers  


Identify the command that displays traffic statistics on serial0/1? A.) display interface serial0/1 B.) show interface serial0/1 C.) show seria0/1 stats D.) show interface serial0/1 stats

1 Answers  


Which of the follwing are true of standard half-duplex Ethernet circuitry? A. It is alternate one-way communication B. The receive (RX) is wired directly to the transmit (TX) of the remote station C. The transmit (TX) is wired directly to the receive (RX) of the remote station D. Collisions are not possible E. Both stations can transmit simultaneously

2 Answers  






8. When is Frame Tagging used? A. When you install repeaters in your network B. When you install bridges in your network C. When you install routers in your network D. When you use Switches configured with multiple VLANS

5 Answers  


The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full

1 Answers  


Can you explain PPP packet format?

0 Answers   CCIE,


What are the protocols that are used by every layer of ip/tcp model?

0 Answers  


what is full form of rst,smtps & http?

2 Answers   HCL,


You are a network administrator and have been assigned the IP address of 201.222.5.0. You need to have 20 subnets with 5 hosts per subnet. What subnet mask will you use? A. 255.255.255.248 B. 255.255.255.128 C. 255.255.255.192 D. 255.255.255.240

2 Answers  


How many Devices does OSPF & EIGRP Support

5 Answers   HCL,


Categories