Answer / guest

Answer: B

Answer / raghav

b

Hi Gyes, here is new question. can you provide answer of following question Like linux, can we windows as router? If yes how can we able to do this,

2 Answers  

---

How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain

3 Answers  

---

what is the difference between osi and tcp ?

8 Answers   Wipro,

---

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---

Which protocol comes under hybrid dynamic type?

0 Answers  

---

What is the purpose of ARP? A.) IP to host name resolution B.) Host name to IP address resolution C.) Mac to IP address resolution D.) IP to Mac address resolution

2 Answers  

---

Which command will give the following output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 0 CTY - - - - - 0 0 0/0 - 1 AUX 9600/9600 - - - - - 0 0 0/0 - * 2 VTY - - - - - 2 0 0/0 - 3 VTY - - - - - 0 0 0/0 - 4 VTY - - - - - 0 0 0/0 - 5 VTY - - - - - 0 0 0/0 - 6 VTY - - - - - 0 0 0/0 -

1 Answers  

---

How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Router(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run

1 Answers  

---

Identify 2 transport layer protocols? A.) IP B.) TCP C.) CDP D.) ARP E.) UDP

1 Answers  

---

In version 11.2 of the IOS, a Cisco router configured for frame-relay can automatically detect the LMI type. What is this known as? A.) Psychic B.) ESP C.) Inverse ARP D.) Hello E.) Reverse ARP F.) Autosense

2 Answers  

---

You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet

1 Answers  

---

How many Frame-relay encapsulation types are available with Cisco routers? A.) Four B.) Two C.) Five D.) Three

2 Answers  

---