Which OSI Reference Layer is concerned with path determination?
A.) Datalink
B.) Physical
C.) Network
D.) Transport
E.) Session
Answers were Sorted based on User's Feedback
Answer / guest
Answer: C
The Network layer is where routing occurs.
Is This Answer Correct ? | 15 Yes | 1 No |
Answer / m haja bahurudeen
Ans: C)Network
Network layer devices router. router determine best path in
routing table.
Is This Answer Correct ? | 7 Yes | 0 No |
here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.
Define the logical link control?
Which of the following is an example of the Network Layer? A.) LLC B.) SQL C.) Token Ring D.) IPX E.) SPX
What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router
Which two types of route table entries are used by a Layer 3 router to determine the appropriate path to destination? (Choose two) A. static route entry B. default route entry C. Dynamic route entry D. temporary route entry E. permanent route entry
What is the default encapsulation of Netware 3.12? A.) Ethernet_II B.) 802.5 C.) 802.2 D.) 802.3
In how many ways can data be transferred in ccna?
Can you explain static and dynamic tunnels?
Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash
Given an IP host address of 172.16.2.160 and a shored mask of 255.255.255.192 to which shored does the host belong? A. 172.16.2.32 B. 172.16.2.64 C. 172.16.2.96 D. 172.16.2.128 E. 172.16.2.192
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department