Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


What is the maximum hop count for IP RIP?

A.) Infinity

B.) 16

C.) 15

D.) 1

Answers were Sorted based on User's Feedback



What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1..

Answer / guest

Answer: C

15 is the maximum hop count, underscoring the size
limitation of RIP.

Is This Answer Correct ?    62 Yes 4 No

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1..

Answer / m haja bahurudeen

Ans : C) 15


16 is host unreachable

Is This Answer Correct ?    39 Yes 2 No

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1..

Answer / mukesh kumar

Answer
(C) Router maximum hop count is 15.

Is This Answer Correct ?    18 Yes 0 No

Post New Answer

More CCNA Interview Questions

The PDU at the network layer is a ________ Packet Frame Segment Bit

5 Answers  


What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  


Identify the command to view the configuration-register value? A.) show register B.) display config-register C.) show config D.) show version

1 Answers  


In static route, what is the difference between next hop ip address and local interface address, except the Administrative Distance.

5 Answers   HCL,


In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to NVRAM before becoming enabled

1 Answers  


Which of the following will show an extended access list 150? A.) sh access-list B.) sh ip int C.) sh ip access-list 150 D.) sh access-list 150 extended

1 Answers  


Request any body to explain the parameters of Ipsec vpn tunnel while creating a tunnel in Cisco ASA.

3 Answers   HCL,


What is the difference between an igp and an egp?

0 Answers  


On which bas ospf take decision?

0 Answers  


Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network

1 Answers  


What is mtu and what is its size for transmission?

0 Answers  


What would be the first command from global configuration mode to enable RIP on your router for interface E0, with an address of 181.86.4.4 and mask of 255.255.255.0 ? A.) router rip B.) network 181.89.4.0 255.255.255.0 C.) router rip int e0 D.) router rip 181.86.0.0 E.) router rip 181.86.4.0 F.) network 181.86.0.0

1 Answers  


Categories