Answer / guest

Answer: A, B, C & D

All four of them can carry PPP traffic. HSSI is High Speed
Serial

Interface.

What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network

1 Answers  

---

What are the different layers of osi model?

0 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains

1 Answers  

---

what is router?

9 Answers   IBM,

---

Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities

0 Answers   Infosys,

---

Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not at the same time

2 Answers  

---

Which statement about half duplex Ethernet operations is true? A. With half duplex transmission frames feed into a single cable in one direction at a time. B. Half duplex transmission between stations is achieved by using point to point Ethernet and Fast Ethernet connections C. Half duplex transmission between stations is achieved by using point to munificent Ethernet and Fast Ethernet connections D. Half duplex Ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end of the connection

5 Answers  

---

How many Frame-relay encapsulation types are available with Cisco routers? A.) Four B.) Two C.) Five D.) Three

1 Answers   Cisco,

---

Do you know how many types of data?

0 Answers  

---

Which of the following are examples of the Application Layer? A.) LLC B.) Token Ring C.) Spreadsheet D.) TCP E.) IP F.) Word Processor

1 Answers  

---

in the ospf area network dr and bdr selection procedure occur let there are 4 router in that n/w r1 have the higher priority then r2 and r2 have higher priority then r3 and so on like that r1>r2>r3>r4 now as we know that selection of dr and bdr based upon the router priority so in this case r1 will be dr and r2 will be bdr now my question is that if i am going to implement 5th router which have greater priority then r1 then will it become dr atomically remember that i am not going change my 5 or 1st router property answer that one please

4 Answers  

---

What is the mesh network?

0 Answers  

---