Which will be more suitable to make a shaft from these - EN8 , EN9 , EN 24. and what will be the life of shaft by these material?
917I have purchased some circlips @rs 100/- p pc on 01.01.2017 ans some @rs.120/- p pc/@rs.90/- p pc dt. 31.03.2017 what is the ending price of per pcs
934If any machinery or trnsmission needs periodic and regular lubrication what is the best method to give?
1263What are the different type of mechanism to engage primary moving engine and transmission [ In other word how many different type of clutches are there
Ford,
1551In order to ensure constant pressure and constant flow rate of compressed air what should we put between the compressure and end user?
1193Post New Mechanical Engineering Questions
please send me previous question papers of rrb chennai applied for junior engineer in mechanical dept
What is meant by gray body?
what is the difference between under vacuum & under pressure boiling?
What for schmidt plot for is used in heat transfer problems ?
Explain the terms solid solution, eutectic, eutectoid and peritectic.
Why in screw & centrifugal compressor using rolor bearing
What is the specific heat of water?
Which element causes difference in higher and lower heating values of fuel ?
Which pipes are used for steam lines?
What are the causes of positive and negative propeller slip?
can i apply for rrb with my provisional certificate..........
What do you understand by heat treatment?
What is the maximum use of magnesium ?
why we r recommended for pre-action sprinklers @ generator/tx/mv panel room. If any leakage there,that panel will damage. So what is the Logic for pre-action sprinklers there?
what are the applications where bearing should not be used though it can be used(economy may be 1 of the reason)