Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT DRESS I SHOULD WEAR WHILE ATTENDING AN INTERVIEW?
PLEASE SPECIFY THE STYLE AND COLOUR.
CAN A LADY WEAR CHUDIDAR FOR AN INTERVIEW?
- 6 Answers
- 15178 Views
- Wipro, I also Faced
- E-Mail Answers
Answer Posted / guest
If you (lay) are not wearing nothing dress u will be easily
selected................. by gents interviewer
| Is This Answer Correct ? | 8 Yes | 23 No |
Post New Answer View All Answers
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
What are the disadvantages of hydropower?
by what factor the starting current is used when comparing star and delta connection for motor starting?
which type of stability limit is higher,steady state or transient? why?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
Why a tesa lamp is glow between two phase?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
what happens when series resonance occurs?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how many safety really of DG sets.
how to do the ductor test?
