Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jayaraju
BE stands for bacheolor in engg. and B.tech is bachelor in
technology. in BE & B.tech the syllabus may be same. BE is
conventional engineer and tech is technologist, where he
understands his requrements and adopts the technology to
suite for his purpuse. todays requirement is to understand
your environment and invent the wheel that is reqiured for
todays need. where BE means inventing a wheel forfirst
time.
| Is This Answer Correct ? | 14 Yes | 6 No |
Post New Answer View All Answers
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
what do you mean by class PS CT and what are technical details needed for calculating it?
Why cables and busbar both needed in LT Panels?
how does this job compare with others you have aplied for?
can you plz send l&t aptitude questions if available its urgent plz plz plz
How to calculate the Efficiency of Chiller
What is miller crystal oscillator? Explain its operation?
When is lag lead compensator is required?
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
How to size Air Circuit breaker (ACB)? What is the most important factors?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
I want single line diagram for AMF & DG syncronizing panel
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
