Interested to Buy Any Domain ? << Click Here >> for more details...
How do you maintain the batteries for generators, what is
the daily maintenance of a generator?
- 2 Answers
- 13808 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / amit kumar sharma
Daily routine test for Diesel Generator
Before Starting
1. Check Fuel Level
2. Check Oil level
3. Cooling Water (For water cooled Generator)
4. Battery Volts and terminals
5. Air Filter
After Starting before loads on
1. Oil Pressure gauge
2. Battery charging ampere
3. Water / Oil Temperature
4. Output supply
5. Output frequency
After Loads on
1. Frequency (check if within acceptable limits)
2. Three phase supply volts
3. Load Sharing on each phase
4. Temperature of Water / Oil
5. Exhaust gas color (Should be clear. Not smoky or black)
IF exhaust gas is black, it is overloaded
If its smoky, oil is leak in manifold, or Diesel quality is
poor
| Is This Answer Correct ? | 41 Yes | 1 No |
Post New Answer View All Answers
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.
design a 3 bit synchronous and asynchronous counter using T- flipflop
How to design harmonic filter at the project stage without nowing the harmonics levels
how test transfomer(3 phase75kva) by megger
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
What is CVT and what is relation with wave trap?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
why tertiary winding is used in transformer with diagram?
HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION
what is the voltage regulation for unity and zero power factor?
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
What will be the diameter of pipe between conservation tank and transformer
how to increase or decrease speed in DC shunt motor by DC convertor
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
