Interested to Buy Any Domain ? << Click Here >> for more details...
wat s the difference between diode and capacitor
- 20 Answers
- 29784 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / k.thulasikannan
Diode is like a switch, capacitor is used for improving the
power factor
| Is This Answer Correct ? | 17 Yes | 8 No |
Post New Answer View All Answers
What is dielectric loss?
What is the comparison of PILC and XLPE cable
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
why star point of HT motor not earthed?
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
What is the working principle of MIG welding? and its out put Voltage?
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
How to calculate Voltage regulation of 22 KV Over head Line.
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
Difference between low impedance and high impedance Restricted Earth Fault
Explain thin film resistors and wire-wound resistors
