At the nozzle throat wats the value of mach no. >1 ,<1 ,=1
- 8 Answers
- 11287 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / chetan
it 'd be greater than one,
t reaches around approx. 1100 m/sec
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Which heating value is indicated by a calorimeter and why ?
In order to increase efficiency and reduce co emissions and other emissions, clear coal technologies are receiving major attention. What are these ?
What are the causes of positive and negative propeller slip?
send me tech quesions please to 470.rajesh@gmail.com
sir,iam applied rrb chennai for the post of junier engineer,i need objective type question book,please refer the suitable book,author and publication.
What is general pressure ratio for axial, reciprocating and centrifugal compressors?
Name the sheet metal hand tools?
increase in unit speed increases the discharge of impulse turbine how?
Draw L.O. system in diesel engine?
what is the pattern of written test for the post of trainee mechanical engg.
What are the types of cleaning main engine Turbo Charger blower side?
Explain the principle of Suizer Fuel oil injection pump
What type of gear is the first reduction gear pinion?
What is the use of pneumatic system?
We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?
