Interested to Buy Any Domain ? << Click Here >> for more details...
what r the types of transmission line?
- 28 Answers
- 52259 Views
- DIET, RRB, WAPDA Water and Power Development Authority, I also Faced
- E-Mail Answers
Answer Posted / banamali mohanta
Two types 1)Primary Transmission and 2)Secondary
Transmission
| Is This Answer Correct ? | 24 Yes | 54 No |
Post New Answer View All Answers
what is the effect of un-synchronized power.
differnce between single acting and double acting solenoid valves
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are gain margin and phase margin?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
what are factors to be consider to design a HT & LT motor?
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
what is the purpose that we use PLC system in power system
Generator,motor and alternator Working principal Please explain easily
How can we findout the maximum efficiancy of Transformer? At which load?
how to commissioning the genset with amf panel?
What facility we get after CT secondary earthing and how?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
