What is the power factor you maintain at ur organization?
- 43 Answers
- 77779 Views
- Cummins, Exide, Johnson and Johnson, KTC, Microsoft, Powergear, Secure Meters, Suncity Strips, Wheels India, I also Faced
- E-Mail Answers
Answer Posted / ronald
power factor regulation is done by connecting the Capacitor
bank- Dry type (Auto- by fixed steps or by manual
regulator) to the main Distribution board MDB.(remember the
baiscs and how cos phi is calculation is made)
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
How to calculate the multiplying factor for energy meter with ct ratio given
what is static frequency converter?what is the function...of sfc...?
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
how to find the Motor,s insulation Power?
What is a commutator?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
State ohm’s law?
How much ph is maintained of water resistance starter for slipring induction motor ?
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
Explain about 3 phase motor fault current calculation with examples?
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
what is the cause of voltage dipp or swell in the transmission lines?
how to calculate mf when meter and cTPT detail are given
