I am mechanical engineer,I need Training in Electrical &
Electronics ( i.e. three days workshop training ) Where
will I get the same Please suggest?
- 2 Answers
- 3864 Views
- I also Faced
- E-Mail Answers
Answer Posted / ssk
Try to areva chennai. there u get mechanical,electrical and
electronics knowledge. it is very useful to ur carrier
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
WHAT IS DEAD END IN PROTECTION?
What is the function of electron gun assembly used in crt?
Define relative stability.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
derive DC RMS value for half wave rectifier?
what is high and low cut off voltage of BB and DG at SPS????????
how open delta PT works & what is its construction?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
Why High voltage are generate noise ?
What is the formula to calculate distribution transformer De-rating on iron losses basis
How to calculate ant test the burden of Current transformer
What are the main advantages of generalized error co-efficients?
What is non-minimum phase transfer function?
what are the steps involved in generator load test?
What do you mean by lighting transformer?
