Interested to Buy Any Domain ? << Click Here >> for more details...
Why use prefer Dc drive in place of Ac drive for kiln
Operatio in Cement Plant?
- 4 Answers
- 12555 Views
- Orient, I also Faced
- E-Mail Answers
Answer Posted / vinod
because of the high torqure requirement.
now a days the motors are converted to ac
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
What are IR values and what it should be for coil and for insulator
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
can anyone provide me a amf panel control wiring using ec-2 relay?
In CTs tan delta point should be earthed , what is the reason behind it?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
How to prepare electrical preventive maintenance plan & shedule of machine tools in manufacturing unit.
Where should the lighting arrestor be placed in distribution lines?
why does rotor rotets?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
What is the formuala to calculate the rating of motor protection circuit breaker
How can we calculate ac current from the given DC current when AC voltage is given?
which VFD is better ( LT or HT)
write down the formula of cable size in RM if current is 50Amp.
