Identify the 2 commands that display the clock rate
configured on
the serial0 interface?
A.) show serial0
B.) show interface serial0
C.) show clock rate serial 0
D.) show controllers serial 0
E.) show running-config
- 5 Answers
- 8477 Views
- I also Faced
- E-Mail Answers
Answer Posted / jerome
First answer is sure B.
the second is a little more complicated.
If the serial interface 0 is DCE, the answer is E because we
have to specify a cloak rate but nothing is written in the
question about that...
If your serial interface is really named serial 0 ( not
serial 0/0 or serial 0/0/0 as the newest routers)the answer
is D.
You will be able to see if your interface is DTE or DCE and
the clock rate used.
( Example :
Cable type : V.35 DTE cable, received clockrate 56000 )
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
What are the advantages of a layered model in the networking industry?
What is the name of algorithm of eigrp protocol?
What is the purpose of the Data Link?
What are the steps of conversion for data encapsulation?
What type of transmission bus topology support?
Which protocols do periodically updates?
Can you explain different components in PKI?
If there is only 2 host in bus topology is that possible collision accord?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
What is the beaconing?
What will be the prefix length of 224 in vlsm?
If bandwidth will increase what will happen?
what are the different symmetric algorithms?
What are the protocol data units (pdu) in ccna?
After how long eigrp protocol advertise its routing table?
