Interested to Buy Any Domain ? << Click Here >> for more details...
what is the ejection system in mould making?
- 3 Answers
- 9251 Views
- Godrej, I also Faced
- E-Mail Answers
Answer Posted / chandu
ejection system will make to remove the produt/component
from the mould with out any damages
| Is This Answer Correct ? | 23 Yes | 1 No |
Post New Answer View All Answers
How many battery discharges?
In order to derive the torsional formulas what are the assumptions taken?
Which furnace burns low-ash fusion coal and retains most of the coal ash in the slag?
How engine design needs to be changed to burn lean mixture ?
how we can calculate natural vibration frequency for steam turbine rotor please.
sir i am selected for HAL Ast. Engg so pls Interview Qus
What are the different values that need to be determined in order to design a cylinder for an ice?
Define thermal conductivity.
In Rankine Cycle we use the concept of Tm(mean temperature of heat addition).In actual cycle the efficiency comes as n=1-T2/T1 Taking Tm into consideration it comes as n=1-T2/Tm as T1>Tm so the efficiency for both case will not same for a same cycle. Can anybody explain how it is possible? Advance appreciation for your effort.Thanks
en 19 & en24 which one is good for pipe mill shaft
In convection heat transfer, if heat flux intensity is doubled then temperature
we use parallel flow heat exchanger to coo oil of 1000 EP viscosity,oftenly tubes may damage during cleaning etc what is proper way to clean cooler? How impurities decreased or vanished during working or in less teme job performed?
what is the difference between fire grate in a boiler and the burner? and is the fire grate is the furnace of the boiler?
why there was 17 stage of compressor in the most of the gas turbine . depending on what?
I need BHEL Engineer Trainee written test papers in Mechanical stream.
