You have two Cisco routers setup back-to-back in a lab using
DTE/DCE
cables. To which router would you add the clockrate command?
A.) The serial port on the DCE router
B.) The Ethernet port on the DTE router
C.) The Ethernet port on the DCE router
D.) The serial port on the DTE router
Answer Posted / guest
Answer: A
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Explain how many maximum paths you can give on latest ios in rip?
Can you explain PPP packet format?
After how long eigrp protocol advertise its routing table?
In how many ways can data be transferred in ccna?
In how many ways you can access the router?
Which feature should a routing protocol have to support vlsm?
When dr communicate with bdr which multicast ip it use?
How can you assign a vlan to a switch port?
What is EIGRP?
What’s the easiest way to remotely configure a router?
How many parts of ping?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
Which protocol switch use for filling its mac-table?
What is formula of hold down time of eigrp protocol?
What we called 64 bit mac-address in ipv6?