Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use Carbon & graphite mixxed brushes in the DC motor?
- 6 Answers
- 17542 Views
- I also Faced
- E-Mail Answers
Answer Posted / prasad
THE PURPOSE OF CARBON BRUSHES ARE TO POLISHING THE SURFACE
OF THE COMMUTATOR AND TO REDUCE THE REACTENCE AT THE
COMMUTATOR.
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
How much no load current of synchronous motor
What is ideal IR values for ground and neutral.
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
boiler is running in rankine cycle and deisel generator is....?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
What is depreciation factor?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
WHAT IS DEAD END IN PROTECTION?
why industry prefer ht motor instead of lt motor.
what is the difference between elcb and rccb ?
Why do we use copper cable for HT Supply and why not Aluminium?
what is ground fault in ACB?
