Identify the type of hardware required to connect a Token ring
network to
an Ethernet network?
A.) Repeater
B.) TR-Enet
C.) Router
D.) Token Ring to Ethernet translation hub
Answer Posted / guest
Answer: C
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is point-to-point protocol in ccna?
How much hold down time of eigrep protocol?
If there is only 2 host in bus topology is that possible collision accord?
What is meant arp and rarp?
What are the advantages of layered model in networking industry?
Explain how many broadcast domains are in switch?
What is the simplest way to remotely configure a router?
What is the attenuation?
In which protocol you manually enable route summarization?
When dr communicate with bdr which multicast ip it use?
How are straight and crossable cables different from each other?
What is the command for change serial cost?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Tell me how many hop counts are by default and how much you can increase in eigrp protocol?
What is difference between switch & hub?