Using the access-list command, 'access-list 1 deny 2.2.2.2',
what
else must be done to stop host 2.2.2.2 from sending any
traffic out of
physical interface E0,
while still allowing other traffic?
A.) In global mode, Add a line - 'access-list 1 permit
0.0.0.0 255.255.255.255'
B.) On interface E0, Add a line - 'access-group 1 in'
C.) In global mode, Add a line - 'access-list 1 permit all'
D.) On interface E0, Add a line - 'access-list 1 in'
E.) On interface E0, Add a line - 'access-list 1 out'
F.) On interface E0, Add a line - 'ip access-group 1'
- 1 Answers
- 4356 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: F
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is the difference between hub, switch, and router?
What is the key advantage of using a switches?
What’s the easiest way to remotely configure a router?
Name which protocols are link states?
Why do you use ‘service password encryption’?
Explain the terms unicast, multicast, broadcast and multicast.
On which bas ospf take decision?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
How many hope count rip or rip2 can send updates?
Which command we give for live view of remote site routers?
After how long eigrp protocol advertise its routing table?
Default packet size of ipv6?
What is difference between rip and ripv2?
Can you describe the Authentication Header (AH) Protocol?
What is the difference between ‘bit rate’ and ‘baud rate’?
