What is the difference between online ups and offline ups?
- 44 Answers
- 211624 Views
- Electrical Tech, GMR, Gravity India, HCL, Indus Towers, NIT, Pyramid, Techno Electric and Engineering, UBS, I also Faced
- E-Mail Answers
Answer Posted / muteka
Online UPS is the one which gives output all the time from
battery whether there is power failure or power on. You
get backing from battery all the time.
Offline UPS supplies Mains to the output when power supply
is regular and charges batteries as well at the same time.
When power fails it switches those batteries to produce
output for power backup.
| Is This Answer Correct ? | 105 Yes | 14 No |
Post New Answer View All Answers
how can we calculate the ratio of caustic soda and water in lrs.
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
what is the difference between the characteristics of two different phase bushing of any transformer
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
battery capacity use of made?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
What is the technical difference between On delay timer and a Star delta timer?
how we calculate the short circuit capacity of the busbar in LV & HT?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
How can two 3 phase transformers of same KVA and Voltage be connected in parallel?
