Interested to Buy Any Domain ? << Click Here >> for more details...
what is runout? how it is measure? which is the refrence?
- 14 Answers
- 98245 Views
- Greaves, Magna Infotech, I also Faced
- E-Mail Answers
Answer Posted / vennela
Runout is specified on cylindrical parts. It is
measured by placing a gage on the part, and
rotating the part through 360 degrees. The
total variation is recorded as the runout.
• Circular runout is measured at one location.
• Total Runout is measured along the entire
specified surface.
Info from :
http://engineering.dartmouth.edu/mshop/pdf/introdr.pdf
| Is This Answer Correct ? | 180 Yes | 11 No |
Post New Answer View All Answers
NOW IAM WORKING QUALITY ENGG ONSHORE ...HOW CAN I CHANGE MY WORK INTO OFFSHORE ? NEED ANY QUALIFICATION ? PLEASE EXPALIN TO ME .....
Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com
What does dynamics of machines deals with ?
What is volumatric air change of a HOT GAS GENERATOR of a STEAM BOILER ?
Is knowledge of properties of engineering materials is significant in pattern making why?
what is the efficiency of horizontal & vertical feed water heaters?
Which are the sheets of metals?
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
What type of pump is are commonly used in auxiliary boilers?
What does f.o.f. Stand for in piping design?
What happens when too much cylinder oil is injected in the working cylinder?
Mention stefan boltzman contant.
what is punching force required for embossing of depth 3.5mm and diameter 58mm
What is the indication of leaking starting valve of an engine?
What is process flow diagram?
