What command will not display the status of to1?
A.) show int to1
B.) show to1
C.) show interface to1
D.) show interface
- 1 Answers
- 5057 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Which protocol can do load balancing on unequal cost also?
How do you configure a cisco router for routing ipx?
Explain the term 'multicast'.
Tell me when we use standard access-list?
Tell me how much hold down time of eigrep protocol?
Explain the terms unicast, multicast, broadcast.
Mention what is the difference between the switch, hub, and router?
What metric does rip use? How is the metric used to indicate an unreachable network?
What are packets?
What is the purpose of a data link?
What is the command use to add a banner to a cisco router configuration?
Explain the difference between baseband and broadband transmission in ccna?
Your company has been assigned the IP address of 201.222.5.0 and require having 20 subnets. As the company’s network administrator, find the following: a) the subnet mask (2 marks) b) the number of useable subnets (2 marks) c) the subnetwork address for the 4th subnet (2 marks) d) the first usable IP address for the 4th subnet (2 marks) e) the last usable IP address for the 4th subnet (2 marks) f) the broadcast address for the 4th subnet. (2 marks)
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
Tell me which cable called roll-over?
