Interested to Buy Any Domain ? << Click Here >> for more details...
What type of frame does CDP use to gather information about it's
neighbors?
A.) TCP/IP
B.) Novell-ether
C.) Subnetwork Access Protocol (SNAP)
D.) Ethernet_II
- 1 Answers
- 6484 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: C
Cisco Discovery Protocol is a proprietary protocol to allow
you to
access configuration information on other routers and
switches with a
single command. It uses SNAP at the Data-Link Layer. By
default CDP
sends out a broadcast every 60 seconds and it holds this
information for
180 seconds. CDP is enabled by default.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
hi friend i am sending some interview question which is asked from me at volvo hope this will help you of all 1 what is mpls al question is posted by jitendera kumar sinha
Why is UDP lease favored when compared to TCP?
Which cable called roll-over?
Tell me which protocol called rapid protocol?
How are internetworks created?
What type of transmission bus topology support?
Why we used Virtual MAC in GLBP
Why is vlan used?
Which protocol can do load balancing on unequal cost also?
Mention what are the ranges for the private ips?
What is the difference between full duplex and half duplex?
Explain the difference between routing and routed protocols?
What is difference between switch & hub?
Tell me which protocol comes under hybrid dynamic type?
What is the terminal emulation?
