What key do you use to view the last command?
A.) Left Arrow
B.) Space Bar
C.) Up Arrow
D.) Right Arrow
- 2 Answers
- 3934 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: C
CTRL+P as well as the Up Arrow keyboard commands will show
the last
command.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN
Which protocol used before part of ccna?
Which command we give for live view of remote site routers?
What do you understand by ‘protocol’ in networking?
Mention what BOOTP is?
Which company mange api's?
Which command we give for see routing table?
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
What is the difference among straight cable, cross cable and rollover cable?
Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)
What is the key advantage of using switches?
Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?
Which LAN switching method is used in CISCO Catalyst 5000?
Tell me which cable called roll-over?
On which interface we always apply access-list?
