Interested to Buy Any Domain ? << Click Here >> for more details...
whether the generating voltage can be made to be
transmitted by means of signals to the recieved end or at
the consumers end?
- 6 Answers
- 9396 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / vidhya
no becoz only higher frequency waves can be transmitted and
received...but ours is only 50 hz..then if u send this
thro' air it starts to conduct at the breakdown
voltage..ie.,30kv so this transmision is not suitable...
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Starting Time of LT & HT Motor
Work done in a free expansion process is
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
I want to know how to calculate the size of electricity cable in building?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
What is purpose of reactor?.What is different between line and bus reactor?
if sf6 gas low in gis what will happen
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
why surge protectetor work explain with the help of circut diagram?
Differentiate between voltage and current feedback in amplifiers?
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
how to calculation increase power factor for single phase
