Answer Posted / manoj k mishra
"if the physical conditions are constant, then the current
through any conductor is directly proportional to the
voltage applied."
"v is proportional to i"
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What happens if the series current double?
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
explain which quantities change in the starting and the and the running condition in induction motor
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
How PADO software increase the efficiency of power plant?
which connection is safer series or parallel?usually which connection we prefer at home?
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
what is a pilot wiring and whys that called a pilot wiers
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
