what is full form of lv and mv? 2.while we connect
capacitor to generator what will cause for it?
- 4 Answers
- 30075 Views
- ABB, Wireman, I also Faced
- E-Mail Answers
Answer Posted / mahesh sonawane
Full form of
lv - Low Voltage
mv - Meadium Voltage.
If we connect capacitor to generator it may act as
additional load on the generator or it may boost up the
generator volatage to higher level for which generator
shuold have some protection and it can be used to improved
power factor as it injects the reactive power required by
inductive load or for the energy saving purpose.
| Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
what is the relation between size of the anteena and wavelenghth of radiated wave
what is the need of starter in tube light and what type of starter is used in that?
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
why and how current drawn by battery charger depends upon the altitude where it is located?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
why the carbon brushes are broken in srim while the motor runningtime
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
Why efficiency of generator is higher than motor at a particular load?
what is meant by directional earth fault and non directional earth fault? describe both.
How are load losses and no-load losses measured at site in a DG set?
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
why we use 630mm single core cable for transformer secondary side and why two neutral cable
How to calculat the ratio of HT\LT in energy meter
